12-03-2002 12:38 PM - edited 03-02-2019 03:21 AM
How can I disable all kind of error detection including appletalk on 6500? I have appletalk routing turns ON, but lot of VLAN interface will show down because 6500 found misconfiguraion on workstations. Please advice.
12-10-2002 11:48 AM
Inband syslog messages are generated when transmit or receive errors are detected. By default, inband syslog messages are disabled.
But if it is enabled,you can use the following command to disable it ":set errordetection inband disable"
For more information on this,you can use the following URL:
http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a00800c65e5.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community