802 ISDN Fast-Step

[bertault]

I am trying to set up an 802 ISDN router using the fast-step utility. It sets everything up but will not dial out or route to anything. It hands out DHCP addresses and I can ping its address but no dial-out. There are no other screens in the fast-step software that deal with setting routing or interesting-traffic so I assumed it set some default values. what would I look at the find my problem?

[rsissons]

The router must see 'interesting' traffic as defined in the DIALER LIST statement in order to trigger the dial out. Check what traffic is specified here. You also need a DIALER GROUP staement under the interface pointing to the DIALER LIST.

[bertault]

Wouldn't fast-step set this up? Where could I find a sample cfg with a simple internet - nat setup? Thanks in Advance