Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
With fast switching enabled (the default), EIGRP will only load balance on a per session level, rather than a per packet level, so any session established over a link will not automatically switch to the lower cost link when the metric is changed whi...
You can use theOutput Interpreter tool on CCO at the following URLhttps://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.plto analyse the stack trace from the crash and determine whether this is hardware or a known software bug.
EIGRP will attempt to load balance so will select the least utilised link. Load balancing however, is on a per session, rather than a per packet basis if fast switching is configured (the default).It is possible to force the router to load balance on...
You use the NM-4A/S, NM-8A/S or NM-16A/S in a 2600. See the following URL for more informationhttp://www.cisco.com/en/US/partner/products/hw/routers/ps274/products_data_sheet09186a0080091b8b.html
You can use the 'Software Advisor' application from the TAC Tools menu to check this. On the 2500 router, it required Enterprise or Service provider. I suspect this is the same for all platforms but I would check for your specific hardware.
