10-21-2003 12:12 PM - edited 03-02-2019 11:09 AM
I connected a Cisco Catalyst 2950 switch in fourth interface of my router 806. On the switch, auto-detection sets the ports 10Mbps/Half Duplex.
Does the 806 router supports 10Mbps/Full duplex ?
Thanks
10-22-2003 12:06 AM
No, it has only a 4 port 10base-T hub.
10-23-2003 10:57 PM
What about the wan eth. interface on 806, it has the duplex commands, but when I try to set it, it does not show in config. Is it also locked to 10/half ?
regards rolf
10-24-2003 12:28 AM
Hi Rolf, no it seems that the wan port is also only 10baseT.
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide