01-19-2004 12:26 AM - edited 03-02-2019 12:58 PM
I have an existing Cat3550-48EMI and I want to add to it a Cat 2950SX.
Is there anything special i have to do. They both have a GBIC Inerface so I will conect them using the SC interface on the Cat 3550 to the MTRJ on the Cat 2950.
Is there any other configuration I need to do as I want to start adding devices to the 2950.
Giving VLAN 1 an ip address on the Cat2950, will it be seen by the network?
Thanks
01-23-2004 08:13 AM
You are planning to trunk between switches I guess. Check the below link for more understanding
Understanding and Configuring VLAN Trunk Protocol (VTP)
01-23-2004 08:33 AM
You'll want to set up a trunk and VTP. I think the 2950 only allows 802.1Q trunking so you'll go with that on the 2550
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: