Anybody using Cat6006 with Sup1A/MSFC2

[adventurer]

Hi, I need to confirm does the old Cat6006 chassis work with a Sup1A/MSFC2 ? I have run this configuration through the software advisor and it is valid.

Anybody with actual experience on this configuration ?

[Prashanth Krishnappa · Accepted solution]

It will work fine. Even a Sup2/MSFC2 will work fine(you just cannot install a SFM in a 600x chassis). Here is an output of sh ver from a 6006 chassis

****************** show version ******************

WS-C6006 Software, Version NmpSW: 7.6(10)

Copyright (c) 1995-2004 by Cisco Systems

NMP S/W compiled on Oct 27 2004, 18:15:59

System Bootstrap Version: 5.3(1)

System Boot Image File is 'bootflash:bootflash'

System Configuration register is 0x2

Hardware Version: 3.0 Model: WS-C6006 Serial #: TBAxxxxxxxx

PS1 Module: WS-CAC-1300W Serial #: SNIxxxxxxxx

PS2 Module: WS-CAC-1300W Serial #: SNIxxxxxxxx

Mod Port Model Serial # Versions

--- ---- ------------------- ----------- --------------------------------------

1 2 WS-X6K-SUP1A-2GE SALxxxxxxxx Hw : 7.1

Fw : 5.3(1)

Fw1: 5.4(2)

Sw : 7.6(10)

Sw1: 7.6(10)

WS-F6K-PFC SALxxxxxxxx Hw : 1.1

Sw : 7.6(10)

WS-X6K-SUP1A-2GE SALxxxxxxxx Hw : 7.1

Sw : 7.6(10)

15 1 WS-F6K-MSFC2 SALxxxxxxxx Hw : 1.2

Fw : 12.1(8b)E11

Sw : 12.1(8b)E11

DRAM FLASH NVRAM

Module Total Used Free Total Used Free Total Used Free

------ ------- ------- ------- ------- ------- ------- ----- ----- -----

1 130944K 49002K 81942K 16384K 9463K 6921K 512K 237K 275K

Uptime is 0 day, 0 hour, 27 minutes

[adventurer]

Thanks for the reply