Apply Service-policy to an ethernet interface

[kpillai]

Hi,

I am trying to configure a policy map to look for certain application traffic using NBAR. I configured the policy to match citrix traffic and assign 25 % bandwidth to that traffic. I am able to apply the service-policy output "policy name" to the Ethernet interface and I could see the citrix traffic getting the required bandwidth using the Show policy-map command.

But I am not able to apply the service-policy input command to the ethernet interface. It takes the command without any error message. But when I do a show run, I do not see the service-policy inout command at all. Also, when I do show policy-map int eth0/0 input, it does not give any output.

IP Cef is enabled, IP NBAR protocol-discovery can classify the traffic details.

I am using IOS (tm) C2600 Software (C2600-I-M), Version 12.2(15)T14.

Any help would be appreciated.

Thanks

Kumar

[m.singer]

Check the following if you are using the shape (percent) command. when this command is used in "child" (nested) policy maps, it is not supported on the Cisco 7500, the Cisco 7200, or lower series routers. Therefore, the shape (percent) command cannot be configured for use in nested policy maps on these routers.