04-21-2004 02:20 AM - edited 03-02-2019 03:09 PM
Could any one tell me how do i enable oam cell on a interface atm without configuring it on a pvc or class vc.
04-21-2004 08:43 AM
Are you looking to enable oam cell on main interface or sub-interface?
04-21-2004 09:15 AM
On the interface!
04-21-2004 09:16 AM
On the main interface!
04-21-2004 09:33 AM
On the main interface I am very sure that you can not. The main reason for oam cell is to send keek alive to the ATM switch for any given sub-interface. Since the man interface has its own layer two configuration to alarm if anything goes wrong with layer one and two. Therefore, there is no need to configure oam cell for the main interface.
04-21-2004 09:45 AM
So how do i configure under the sub-inteface?
04-21-2004 10:08 AM
I would like to know, what is your main reason to enable oam cell without configuring a pvc or class vc.
04-21-2004 10:22 AM
The reason is that a friend of mine take this question on cisco exam and he didn't know how to answer, so my question is if it is possible or not to configue oam not under the pvc or class vc
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: