11-27-2003 08:52 PM - edited 03-02-2019 12:01 PM
Hi,
I want to know how I can find out backplane utilisation in Cat6500 & 4000 series switches.The output of 'show traffic & sh system' not that much informative.
Regards,
Shibu
11-28-2003 12:30 AM
I don't know if you are using IOS or CatOS, but if you are using IOS, at Cat6500 you can try "sh catalyst6000". I don't know is there a similar command at Cat4000.
HTH
11-28-2003 05:09 AM
We have CatOS. Please let me know which command we have to use.
Regards,
Shibu
11-28-2003 05:28 AM
I think there's no other commands for such task. Anyway, maybe you might consider trying it by SNMP.
Please, take a look at "How to Get Catalyst Switch Backplane Utilization Using SNMP":
http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094a96.shtml
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide