Can CW2K support SSH instead Telnet or Both?

jbhakta · ‎03-08-2003

I have problem connecting to monitered device through Telnet. If i have SSH enabled on device, Does CW2K will able to connect to device through SSH?

Thanks in advance.

Jay

rmushtaq · ‎03-08-2003

Yes, for Config Management, it depends on the order set under RME->Administration->Config Management->General Setup->Transport Setup and set the order.

milan.kulik · ‎03-10-2003

But my understanding was that some CW components (Campus Manager, e.g.) were not SSH compliant? And could not be installed on the same server as RME using SSH then?

Regards,

Milan

rmushtaq · ‎03-10-2003

What you're referring to above is the SSL/https compliance and not SSH. Yes, Campus Manager is not SSL/https compliant and cannot be install with RME is SSL is enabled. But the question here is related to SSH and not SSL/https.

obrien-r · ‎05-27-2003

To follow this on the SSH issue, the above mentioned steps cover RME, but is there a way to get Campus manager, Ciscoview etc to use SSH? Can the underlying files be modified to change the command pushed down to the client?

Thanks.

jbhakta · ‎03-10-2003

There are only three Transport protocol on list TELNET, TFTP and RCP.

I don't have choice for SSH.

Thanks

rmushtaq · ‎03-10-2003

Support for SSH was added in RME 3.4 and later only. If you're running RME 3.3 and earlier versions, you will not see the SSH option in settings.

jbhakta · ‎03-11-2003

Thank you very much.

Jayesh

richard.whitlock · ‎05-21-2003

What about devices that do not support SSH yet?

If I set the order to SSH, TFTP, Telnet, RCP how will this affect devices that are not SSH capable.

I am assuming that if they do not support SSH then they will try the next options, in order and should still work.

There is a ssh client of some sort built into CW2K so no further set up is needed for CW2K to use SSH.