12-11-2003 12:28 PM - edited 03-02-2019 12:18 PM
I would like to connect a 3550 switch to a 3745 router utilizing an FastEther channel. I located documentation on how to connect a 7500 router to an Catalyst 6500 but is doesn't work with the 3550 and 3745. I can get everything configured but can not ping the other end of the channel. Anyone done this? I want the channel to be a L3 link.
Any help would be appreciated.
12-11-2003 11:01 PM
Etherchannel is typically a Layer2 feature.
With a router, it might be a better way to use two seperate links. It will do load balancing and failover, just like a channel.
For a channel, you would need loopback interfaces or someting like that to assign an IP address to.
Could you please upload how you configured this?
Regards,
Leo
03-09-2004 03:16 AM
Hello,
Did you find solution?
We have the same problem (using 3745 and 4006).
Regards,
Daniel
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide