We have been trying to create a multilink frame relay connection on one of our routers and have not been successful in the first step - creating a mfr interface. I think this should be pretty cut and dry, but obviously I have missed something.
In a nutshell I get an invalid command when I try to create the mfr interface.
Here are the steps I have taken.
1. Enter enable mode
2. Enter global config mode
config t
3. Create mfr interface
(config) # int mfr 0
At this point I receive an invalid command and the pointer rest under the "f" in mfr. If I use help (int ?) I can verify that mfr is a valid command
option. If I go further with help ( int mfr ?) it will prompt for the interface number ( 0 - xxxxxxxx).
Once I enter a interface number I again receive the invalid command with the pointer resting again under the "f" in ' int mfr 0'. Any help would be greatly appreciated.
Router - 2620
IOS image - c2600-ipbase-mz.123-6c.bin
Flash - 16 Memory -64
Also, this is a functioning router running two separate frame relay interfaces with numerous subinterfaces currently.
Thanks,