Other Network Architecture Subjects

Is there an upgrade for CiscoWorks that is supported on Windows 2003? If not when will an upgrade be available?

Hello,Maybe this is just a simple problem, but i can't solve it.I have the following problem:I try to connect the 3550 with an 2924 XL, using a trunk with cross cable. I try dot1q both sides because isl is no more possible on the 3550.My router is co...

Cisco 1601 router with integrated csu/dsu spontaneously places the serial1 port into looped mode, if I reload the interface status is up and up, at various intervals of time the interface will show up and up (looped) ,the loop led on the csu/dsu is l...

hi everybody, I ve just setup my new CW LMS2.2 Campus Manager 3.3 on solaris system, and I have the same problem. "ERROR: An Error occurred communicating with your ANIServer" my hosts file is ok, java version is ok,but only thing I couldnt find reini...

I have 2 offices connected by a T-1 line. One office is unable to receive internet service, so i set up a NAT from one office to the other to allow for internet service to reach the non-internet office. The systems works great, Road Runner ISP provid...

We have a 10.x.x.x/16 internal network. At the core of the network I often see packets with the address 10.255.255.255 showing up and getting a redirected at the inside of the firewall back into our network.This happens after the packet has traversed...

Oid processorRam(1.3.6.1.4.1.9.3.6.6) can't used on 6509 switch .I used sum of ciscoMemoryPoolUsed and ciscoMemoryPoolFree to get the processor Ram. And are there any other oid can be used to get the information directly? Can anybody give me some ti...

Hi,I have 2 6500(hybrid) as distribution(core) with 4506 on the access. Each 4506 has got connections from both 6500. I have multiple vlans and configured one 6500 to route odd vlans and the other 6500 route even vlans with HSRP running between them....

Hello All:Just getting my feet wet with routing and need a little help with a configuration.Have a segment of the network routing out through a 1720. Set up now with FA0 10.0.2.250 (lan gateway)and SER0 63.148.226.xWhat I need to do is drop a sonicwa...

i have an existing router(AS5400 IOS 12.2(2)XB12) which works flawlessly with my radius server(XTRadius)..now i want to add another NAS for my radius server.. a 3640 router (12.0(7)T) that is. and it has 3 16AM(Analog Modems) network modules..now i c...

Hi, I've got a router and when I ping my own IP address (on a point-to-point subinterface) the ping fails because on the other side of the link I've got a device not responding to ICMP echo request (this is correct as I read on in this forum). The pr...

I have branch with fr connection to central sit and ISDN BRI backup. In case of backup I am using both B channels. If I want to make an analog call on NT port, I cannot because both channels are taken by router. How can I make router free one channel...

Can channel port form between GE-MT and GE-TX?

Hi all,I am trying to setup MRTG to monitor my pix 515 for incoming and outgoing traffic.I installed MRTG and perl, then create a cfg file.See below for my file:# Cisco Pix 515WorkDir: c:\Inetpub\wwwroot\mrtgTarget[mbcpix]: public@10.1.1.1MaxBytes[mb...