i am using a cat 6000 running on CatOS 6.3.3.
when doing some testing i noticed that the temperatures shown by the command
show env temp
are never changing (except the supervisor's temp).
so for example in the first measurement:
Intake Exhaust Device 1 Device 2
Slot Temperature Temperature Temperature Temperature
--------------- --------------- --------------- --------------- ---------------
1 28C(50C,65C) 36C(60C,75C) 30C 37C
2 26C(50C,65C) 35C(60C,75C) 30C 38C
3 28C(50C,65C) 31C(60C,75C) N/A N/A
5 37C(50C,65C) 34C(60C,75C) 32C 32C
6 33C(50C,65C) 33C(60C,75C) 31C 33C
7 32C(50C,65C) 37C(60C,75C) 31C 32C
8 33C(50C,65C) 37C(60C,75C) 31C 34C
9 35C(50C,65C) 37C(60C,75C) 33C 36C
1 (Switch-Eng) 28C(50C,65C) 32C(60C,75C) N/A N/A
2 (Switch-Eng) 31C(50C,65C) 35C(60C,75C) N/A N/A
1 (MSFC) 33C(50C,65C) 40C(60C,75C) N/A N/A
2 (MSFC) 32C(50C,65C) 37C(60C,75C) N/A N/A
after increasing the room temperature (approx. 6°C the command output was:
sh env temp
Intake Exhaust Device 1 Device 2
Slot Temperature Temperature Temperature Temperature
--------------- --------------- --------------- --------------- ---------------
1 28C(50C,65C) 36C(60C,75C) 30C 37C
2 26C(50C,65C) 35C(60C,75C) 30C 38C
3 28C(50C,65C) 31C(60C,75C) N/A N/A
5 37C(50C,65C) 34C(60C,75C) 32C 32C
6 33C(50C,65C) 33C(60C,75C) 31C 33C
7 32C(50C,65C) 37C(60C,75C) 31C 32C
8 33C(50C,65C) 37C(60C,75C) 31C 34C
9 35C(50C,65C) 37C(60C,75C) 33C 36C
1 (Switch-Eng) 28C(50C,65C) 32C(60C,75C) N/A N/A
2 (Switch-Eng) 31C(50C,65C) 35C(60C,75C) N/A N/A
1 (MSFC) 39C(50C,65C) 45C(60C,75C) N/A N/A
2 (MSFC) 38C(50C,65C) 43C(60C,75C) N/A N/A
is this a normal output? What temperature is shown on the slots and why doesn't it change?
