Catalyst 4000 configuration question

[msalim11]

We just bought a new catalyst 4000 switch. I connected to the switch fine through console port, but when I tried to use " show config command, I get a message, "non-volatile memory is not present". I cannot configure any settings, even the ip address. Does anyone know what does it mean? When I type "show tech" command, it run and scroll through all configuration info on the terminal screen. Any help will be appreciated.

Thanks,

[Georg Pauwen]

Hello,

Can you post the output of the ´show version´ command, if the system allows you to do that ?

What is the configuration register setting ?

Regards,

Georg

[msdonahue]

try a "show run". Also, type in "copy run start" and then try a "show conifg".