08-03-2003 08:16 AM - edited 03-02-2019 09:19 AM
I have two Catalyst 6509 with the same configurations. In each 6509 I have four WS-X6316-GE-TX blades. I have the CallManagers connected to the 6509s. However, I am unable to receive a DHCP address. Then, I move the CallManagers to a 10/100 3548 switch and I can get DHCP fine. I have other servers connected the same way I am trying to connect the CallManagers and they get DHCP fine. I have even tried different port without success. Any ideas?
08-03-2003 02:11 PM
The first and most obvious question is whether you've configured the ports on the 6500s to PortFast etc. If not that explains it.
Check out:
This page may prove useful too:
08-03-2003 03:37 PM
I used the set port host
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide