cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
237
Views
0
Helpful
1
Replies

Cisco 4948 -- Link up Link down traps - Missing Trap Components

sanidhya
Beginner
Beginner

Cisco 4948 -- Link up Link down traps - Missing Trap Components

Hi Guys ,

While simulating traps via making a link down and again up , Cisco 4948 is sending the OID 1.3.6.1.6.3.1.1.5.3 to our monitoring device .
But it seems below variables /trap components are missing with the OID , does anyone have any hints about this ?

ifIndex
ifAdminStatus
ifOperStatus

My SNMP configuration is like

snmp-server community public RO
snmp-server community private RW
snmp-server trap link switchover
snmp-server trap-source Vlan102
snmp-server location NY
snmp-server contact XYZ
snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart
snmp-server enable traps tty
snmp-server enable traps cpu threshold
snmp-server enable traps envmon fan shutdown supply temperature status
snmp-server enable traps config
snmp-server host x.x.x.x version 2c public

Thanks & Regards

Rengith Kumar RS

1 Reply 1

Ben Samayoa
Beginner
Beginner

hi there,

What is the IOS you're running on your 4948?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers