cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
358
Views
0
Helpful
1
Replies

Cisco 678 NAT Configuration

glenna
Level 1
Level 1

I am having a hard time configuring my 678 router.

My internal network is 10.1.1.# with a mask of 255.0.0.0

My public ip is 207.###.###.###.

I want to configure the following:

NAT at 10.1.1.91

PCAnywhere pointing to a PC at 10.1.1.8

show int gives me:

eth0 10.1.1.92 255.0.0.0

vip0 207.###.###.### 255.255.255.248

vip1 0.0.0.0 255.255.255.0

vip2 0.0.0.0 255.225.255.0

wan0 Physical Port: Trained

wan0-0 0.0.0.0 255.225.255.0

wan0-1 0.0.0.0 255.225.255.0

VIP1 has been both inside and outside.

VIP1 has also been at 10.1.1.91

=====================================

show nat is all 0s except for

wan0-0 outside 207.###.###.###

vip0 outside 207.###.###.###

I know how to issue the commands.

I just cannot figure out how everything should look.

Thanks in advance.

Glenn Abelson

glenna@abelson.com

1 Reply 1

ciscomoderator
Community Manager
Community Manager

Often times complex configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.