we have cisco catalyst 2900xl switch in which i connected my customers. i want to restrict my LAN clients so that they can use some restricted bandwidth (ex: 32kbps/64kbps etc). pl. some one help me in this regard.srinivas
I have a 6509 with 2 x MSFC2 cards installed. We had a power outage and the following happend:The Cat6509 did not start properly, the 1st PFC2-MSFC2 module was in fault and the second one was okay. When logging onto the console port The 1st PFC2-MSFC...
Hello,i need to make many span monitoring port group, but i can't congratulate when i want to make 3 or more span monitoring port!anybody know how ( if it's possible) to make more 2 span monitoring port on c3524?Thanks!
I am relativley new to OSPF and I have a question regarding Route propegation. If I have the following entry:router ospf 1 redistribute connected subnets redistribute static subnets passive-interface FastEthernet1 network 10.0.250.1 0.0.0.0 area 0.0....
I am pretty new to the world of networking, I am actually a s/w developer. However, I have been recently given the task to implement load balancing between 2 web servers utilizing just a cisco 2620 router. My questions are: 1. Is this possible. 2. If...
I'm currently researching ways to establish redundant connections between a 7513 and multiple HP switches operating in a switch mesh. My first thought was to use hsrp on two Fast E interfaces on the one router, but further reading has shown me that ...
I have a few network stations (X terminal devices) that connect to a unix server with the X11 protocol. These station seem to eat up tons of bandwidth, broadcasting to every port on the network. We are a fully switched network, yet I can see all the...
Hi, I hope someone can solve my problem.I have an EIGRP topology and want a directly connected network on some edge routers not in the routing table. Because of older release the network-command is classfull (no mask option available) and the network...
I am relativley new to OSPF and I have a question regarding Route propegation. If I have the following entry:router ospf 1 redistribute connected subnets redistribute static subnets passive-interface FastEthernet1 network 10.0.250.1 0.0.0.0 area 0.0....
Does anyone know if there is a mib variable I can queery to get the equivalent of "show ip nbar protocol-statistics" . There is a QoS MIB for traffic classes if you are using policies but this reports on applied QoS traffic classes etc.
I'm running ut 3.01 (on cw2k) and can't see portnames being pulled off cat3500s, cat4000's appear fine though. Would be really useful for us to see them all in one place as all our room port patching assignments are recorded in the description field ...
Hi, I have a problem with my Cisco 1401 router (ADSL connection).Sometimes i can't access to Internet, and the only solution is to switch off and switch on the router.Then the Internet connection is again operational.Here is my diagnostics :When the ...
Hi,I have a Router Cisco 801 with a simple ISP connection.Now i want to add a new connection to a Global Extranet (like a second ISP).I have configure two Interface Dialer and two Access lists like this :interface Ethernet0 ip address 192.168.100.100...
I am setting up a Cisco 2509-RJ to provide Dial-In access for Remote Windows Dial-Up Networking Clients. So far the client can connect, authenticate retrieve a DHCP IP address, DNS, and WINS settings, and even utilize TCP/IP network resources for al...
I recently bought a 7206 Router on ebay. I don't have the passwords to get into the router. How do I remove the configuration from the router and start from scratch?
