Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
286
Views
0
Helpful
1
Replies

Cisco 7204 vxr 8 port PRI adapter PA-MC-8TE1+

John Gowen
Level 1
Level 1

‎07-12-2004 02:59 AM - edited ‎03-02-2019 05:00 PM

I am attempting to install an 8 port high density PRI module in a Cisco 7204 VXR. I can't even get the card enabled on the chassis. the 7204 is an NPE 300 has 160Mbs of memory. I have tried all the minimum recommended S/W levels. Has anyone else had difficulty with this combination?

Labels:
0 Helpful
1 Reply 1

vkapoor5
Level 5
Level 5

‎07-16-2004 06:15 AM

Please use type global configuration command like "Router(config)# card type t1 1". After this only, the card will show in the configuration. And also remember that until you make a port active, the AL LED will be ON. Please refer the following link for more information.

http://www.cisco.com/univercd/cc/td/doc/product/core/7200vx/portadpt/multicha/8port_t1/2738cfg.htm

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card