Sorry to post such a newbie question, but, I am not a network admin, but, I have been forced into the role for a project I am working on.
Here is my problem:
I have to extend our network from our warehouse to another off-site warehouse via an ISDN line (IP traffice only). I purchased two Cisco 800 Series routers and have used the "Fast Start" software to configure both of them. I know I have the ISDN information (spids, etc.) correct and the line seems to be connecting (I watched via Monitor), but, I can't seem to get the IP traffic to route correctly.
Here is the basic IP info....
Current warehouse:
10.17.x.x
255.255.0.0
New warhouse:
10.20.x.x
255.255.0.0
Can anyone give me any suggestions on this problem?? I know this isn't much information, but, I am not sure what to post...
