04-14-2003 12:32 AM - edited 03-02-2019 06:38 AM
Could you please help ... DFM notice to I/O insufficient memory. 1c hannerized T1PRI + 2 Fa Ether are used. Tried to use Memory Culculater on TAC. However, it does not make sence.
What is the appropliate memory allocation rate on this router ?
****************************
cisco 2621 (MPC860) processor (revision 0x102) with 28672K/4096K bytes of memory
Primary Rate ISDN software, Version 1.1.
2 FastEthernet/IEEE 802.3 interface(s)
24 Serial network interface(s)
1 Channelized T1/PRI port(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
**********************
Head Total(b) Used(b) Free(b) Lowest(b) Largest(b)
Processor 80B58B54 17462444 3420020 14042424 13721964 13700324
I/O 1C00000 4194304 3837112 357192 357192 350268
04-14-2003 06:35 AM
Is this DFM 1.2 with IDU 1.2.4 installed?
04-14-2003 07:25 PM
Yes, DFM1.2 is installed. what's IDU ?
Thank you,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide