03-05-2003 04:47 PM - edited 03-02-2019 05:36 AM
Hello,
I need urgent help. I run c2500-is-l_112-18.bin on 2503.
The normal prompt must be:
ROUTER> (user mode)
ROUTER# (enable mode)
I have:
ROUTER (user mode, note that ">" is missing)
ROUTER (enablemode, note that "#" is missing)
Moreover, when I went to config mode I had this:
Hostname(config)# (in config mode the hostname appeard, I thought it must be the same as Prompt.
I suspect bug or IOS corruption in the flash. Please advise how to fix it.
Thank you
Solved! Go to Solution.
03-05-2003 09:37 PM
Hi, This is not a bug.
This is normal behaviour. Your router seem to have the Prompt command configured. The prompt is applied only to enable and user modes. So by removing the prompt command, your hostname would be displayed properly in all modes ( user, enable, global config).
03-05-2003 09:37 PM
Hi, This is not a bug.
This is normal behaviour. Your router seem to have the Prompt command configured. The prompt is applied only to enable and user modes. So by removing the prompt command, your hostname would be displayed properly in all modes ( user, enable, global config).
03-06-2003 04:10 PM
Thank you very much.
You right it was config "bug". One CCNP told me that i have to replace IOS.
Good stuff!!
Cheers,
Vitaly
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide