Configuration Rollback - lock.error message

[vzufferey]

I try to do a configuration rollback on a cisco 1760 - 12.3(14)T. I have a lock.error message.

Any Idea ?

ftzuv04r#configure replace flash:ftzuv04r-confg-1

This will apply all necessary additions and deletions

to replace the current running configuration with the

contents of the specified configuration file, which is

assumed to be a complete configuration, not a partial

configuration. Enter Y if you are sure you want to proceed. ? [no]: y

Apr 7 10:50:59 CH: Rollback:Acquired Configuration lock.Error: could not write to output buffer incremental-temp.cfg

Rollback aborted after 1 passes

[beth-martin]

You normally get such messages when there is some problem with the roll back configuration. Please refer to the following URL which explains the configuration required for Rollback to happen.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123newft/123t/123t_7/gtrollbk.htm