05-03-2004 03:34 AM - edited 03-02-2019 03:25 PM
Hello
what(cable, adapter...) does I need to connect my 2610 router WIC 1T interace to my catalyst switch ethernet port ?
Thanks.
Alain
05-03-2004 12:32 PM
I am not really understanding what you want to connect and where, but if you are trying to connect the T1-WIC interface on a router to a switch, that will not work.
Can you clarify
05-04-2004 03:04 AM
Of course, I want to connect my router WIC 1T serial interface port to the ethernet switch.
There is no adapter for that? How about V.35 serial câble?
Thanks for reply.
Alain
05-04-2004 03:08 AM
No you cant connect WIC 1T card to a Catalyst switch. If you want to have a connection between the router and switch, you can use ethernet( RJ-45) straight cable.Ex: e0/0 of 2610 router connected to port fa2/1 of Catalyst switch.
05-07-2004 05:05 AM
Ok, many thanks for that information.
Now can you tell me wich CISCO interface card I can buy to replace the WIC 1T and connect my router to the Ehetnet switch port.
Thanks.
05-07-2004 11:25 AM
NM-2E2W, NM-2FE2W, NM-4E, NM-1E
Check
http://www.cisco.com/en/US/products/hw/routers/ps259/products_relevant_interfaces_and_modules.html
LAN Network Modules and LAN and WIC Combo Network Modules section
05-10-2004 04:30 AM
Thank you very much.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide