Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am planning on setting up multicast in the lab. Was wondering if anyone can point me in the right direction for a freeware multicast stream source. TIA
Hello, I am looking for freeware or software that can say once a week dial out to our remote cisco routers and report back that the status is ok. I know there is something out there that can do this, just have not come across it. Currently this is ...
The call drops exactly every two hours, then redials. Here is the debug: Call State i = 0x0A001558: Jul 27 15:06:28.734 CDT: ISDN BR0 Q931: RX <- RELEASE_COMP pd = 8 callref = 0x8C Cause i = 0x82A9 - Temporary failure Locking S...
Hi,Is there a way to set up a lock and key acl for a host behind the ethernet segment on a router? i will be attempting to access this host over a serial connection, but I need to add 'permit ip any any' on the acl because it will be appllied on the...
Hi,Your probably going to need the command:'card type t1 0 0' The 0 0 depends on what slot you have the card installed in I believe.The the controller config will then show up.
Hello,I recently put some of these in the other week and have the same error messages. All I could find was a reference to use the Onboard Administrator to resolve the issue. Since I do not manage the server aspect of these, the ports are still in ...
Hello,Cisco View lets you manage devices via GUI within Cisco Works. I have always found it a bit hokey. By the time I log into Cisco Works, launch Cisco View, then find the device to make any changes, I could have already accessed the device and m...
Have you tried something like this:route 0.0.0.0 0.0.0.0 192.168.x.xvirtual 192.168.2.10:23:0:tcp isreal 192.168.2.11:23:0:tcp isbind 192.168.2.10:23:0:tcp 192.168.2.11:23:0:tcp
