Connecting a Cisco2620 to a OmniPCX 4400

[giaaaj]

We are planning to realize a Voice and data over WAN Connection, with the use of CISCO2620 and Omni PCX 4400 ( with Nx64: multible 64 Kbps Synchrounous channels).

The Characteristics of the nx64 on the OmniPCX 4400 are

- Interface : Compliant with CCIT-X24/V11 recommendation

- EIA standard: RS 422 A

- Speed 64,128,256,284,512,1024,1536,192 KBPS

-Communication mode : DCE/ETCD

Could somebody pls inform what is the exact desc. of the WAN Card and the Cable that i schoul use on the CISCO2620 Router ( the LeasedLine is 2Mb , 512 will be used for voice and the rest for DATA.).

Thanks

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.