Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
454
Views
0
Helpful
2
Replies

CW2K software distribution

bw3481
Level 1
Level 1

‎12-12-2002 07:28 AM - edited ‎03-02-2019 03:34 AM

Is there a way to increase the timeout value or number of tries when trying to run a job to distribute images to 2900 series switches? I have submitted several jobs, usually with around 10 switches to upgrade the IOS. The job normally fails with at lease 50% of the switches not receiving the upgrade. If I simply resubmit the job (I am making no changes), it normally finishes the failed devices.

I receive the following message:

Device cannot be connected via Telnet. Skipping the software upgrade on this device.

Error Info Code: '4019'

Thanks in advance.

Ben

Labels:
0 Helpful
2 Replies 2

rmushtaq
Level 8
Level 8

‎12-12-2002 10:04 AM

Not for SWIM. SNMP timeout and retries only affects the Inventory. An alternate way would to run SWIM jobs in smaller number. In your case may be 5 at a time?

0 Helpful

bw3481
Level 1
Level 1
In response to rmushtaq

‎12-12-2002 10:42 AM

Submitting 5 devices at a time would be extremely painful, since I am doing several hundred in the end. It will probably be faster to just keep re-submitting the jobs then creating new ones.

Thanks for the reply.

Ben

0 Helpful
Customers Also Viewed These Support Documents