11-03-2003 02:43 PM - edited 03-02-2019 11:26 AM
How do I delete previously configured sub-interfaces?? I have a 2650xm running 12.3.3 on which three frame-relay sub-interfaces were defined. These were on serial 0/1 ie s0/1.403 etc then config deleted and removed to put the interfaces on s0/0. But the deleted interfaces still show in show ip interface brief as a method of unset. There is now config left in and each line was removed individually (not just the interface).
11-03-2003 03:33 PM
As far as I know, a reboot of the router is required.
11-03-2003 04:00 PM
I found the issue. Some tunnel interfaces had not been corrected to use the new sub interfaces.
Thanks any way to any one who reads this.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide