DFM Alarm

[M.Miyakawa]

any system error recognized C6500 but DFM alerm is come up all the time.

description:HighQueueDropRate,HighUtilization,High Broadcast Rate etc...

How do I check these.

[mchin345]

Hello Miyakawa,

I am not sure if this is your exact requirement, but you can customize the view using filters. Filters are used to control information in the Alarm Log view so you can immediately recognize the important messages. Only incoming notifications that match your filter criteria are displayed

Go here for additional information and for steps to Customize the Alarm Log View with Filters:

http://www.cisco.com/en/US/customer/products/sw/cscowork/ps2421/products_user_guide_chapter09186a008008053e.html#80668

Hope that helps,