cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
357
Views
1
Helpful
2
Replies

DHCP SNOOPING/DYNAMIC ARP INSPECTION

chukwuma
Beginner
Beginner

what is the difference between an IP DHCP snooping trust interface and a dynamic inspection trust interface. 

I'm asking in regards to where the switch interfaces where they should be configured points to.

1) can we configure it on an interface pointing to a PC

2) can we configure both DHCP SNOOPING trust and dynamic ARP INSPECTION trust on the same switch interface?

 

 

1 Accepted Solution

Accepted Solutions

1) can we configure it on an interface pointing to a PC

NO CONFIG IT ONLY TO PORT TO DHCP SERVER 

2) can we configure both DHCP SNOOPING trust and dynamic ARP INSPECTION trust on the same switch interface?

IF YOU RUN BOTH DHCP SNOOPING AND ARP INSPECTION THEN BOTH COMMAND NEEDED AND CAN CONFIG IN SAME INTERFACE 

View solution in original post

2 Replies 2

1) can we configure it on an interface pointing to a PC

NO CONFIG IT ONLY TO PORT TO DHCP SERVER 

2) can we configure both DHCP SNOOPING trust and dynamic ARP INSPECTION trust on the same switch interface?

IF YOU RUN BOTH DHCP SNOOPING AND ARP INSPECTION THEN BOTH COMMAND NEEDED AND CAN CONFIG IN SAME INTERFACE 

chukwuma
Beginner
Beginner

Thanks for the response.

I appreciate 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: