Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
what is the difference between an IP DHCP snooping trust interface and a dynamic inspection trust interface. I'm asking in regards to where the switch interfaces where they should be configured points to.1) can we configure it on an interface pointin...
I'm using Packet Tracer and Everything was working just fine in a network I'm building.. Not until I wanted to add a wireless functionality to my network.I then introduced a CONTROLLER to that switch,..gave it an IP addresses and a default gateway c...
Please I am taking a training with Packet Tracer. Along the line, I needed to add a MetroE in a WAN, but I couldn't see maybe 'a device' I can use in packet tracer to represent the metroE to be able to configure the metroE on the router interfaces. A...
Hello,using packet tracer, i was trying to set the duplex of some interfaces both router and and switch but i keep get that invalid input sign(^) under the "d" in the word "duplex". Then i tried to use the question mark to check if duplex is among th...
USING PACKE TRACER,AFTER ISSUING THIS COMMANDS:AZ-SWO1(config)#int gig 1/0/1AZ-SWO1(config-if)#desAZ-SWO1(config-if)#description "CONNECT TO AZ-SW03 FAS0/2"AZ-SWO1(config-if)#AZ-SWO1(config-if)#^ZAZ-SWO1# I NOW RUN SHOW INTERFACE STATUS. BUT THE DESC...
I am having same experience. I Heartily appreciate and understand this you response. But please how can someone solve the problem that gives U.U.U error message!
I have tryed all i could. Went through all my lectures again. Yet i cant ping from the PCs' to (or log into) the controller to be able to set it up.. I need that help please.Also, i cant ping from the WIRELESS PC to the AZ-RT01.The zipped file of the...
