Dial In with Cisco700 with a Username with a delimiter

[rfriedri]

Hi!

Does anyone of you know an issue about using a delimiter in the username configured on a Cisco700?

A customer has problems on dialing in with a 700 when placing i.e. test@test as an username.

The Aggregating Router does not see the additional Information of the @test.

Is there any problem with LCP ? Do I have to configure some special things on the 700 ?

thank you

cheers

Roman

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.