Other Network Architecture Subjects

Lets say I have 4 branch stores, including the main store which has the network ID I want to use. The main store has a net ID of 192.163.123.0. The branch stores are, 192.163.124.0, 192.163.125.0 and 192.163.126.0. Lets say I have a machine at the ad...

Hi,We know that BGP maintains a different routing table from IP, and there is procedure to compare the Attributes in order to install a route into IP routing table.My question is that is there any criteria to be met in order to install a route into B...

Hi there,Can somebody tell me how to set up an C827-4V as DSL-Router(PPPoE) on german Telecom DSL (T-DSL) ?ThanksChris Schuster

How do I configure my UBR 7200 to deny my cable customers from using "linksys" type DSL/Cable routers on my network, and prevent the theft of service that these can enable. Is there a hot sheet of MAC addresses (mfg. code & model code) for these de...

In the last a few days, our cisco2924XL switch reported a couple of times that one of the ports wasdown and up by itself with no reasons. The interval between down and up was one or two seconds. This port connects the file server and about twenty wor...

We are phasing out a 5500 switch and setting up a 6500 catalyst in its place. The 5500 is set up as the only VTP server and connected to other switches using ISL trunking. The 6500 will be connected to the domain as a second VTP server. My question ...

How PIX Firewall can apply on VoIP? Any sample configuration and recommendation?Thanks.

I am currently in the process of researching QoS for our company. Our main concern right now is ensuring that specific data types (IE Telnet for 5250) have priority over HTTP traffic, but we also want to be able to specify that our web based applica...

Hi, i'm wondering if MPLS is supported on cat6000/6500 family.if positive, what role can a cat6000 play in a MPLS network. can it serve as PE or P router? or both? is any special module gonna be required on cat6000 in order to fit itself in the MPLS...

I have two sites that have a 2600 with 4 port serial cards and are connected via fram relayHow do I configure the router to setup site A with a Wyse 50 Terminal on the network to print to a serial printer hooked up to one of the serial ports on site ...

We have a bandwidth issue with one of our locations. It's connected to our main office through a PPP T1. The main application that is being used is telnet. We have several application servers that are centrally located at our main office and when ...

Here is my hardware setupDual C6K 6509 w/SUP2/MSFC2/PFC2Cat6000-sup2cv.6-2-2.binSwitch Fabric Module 216 port GIG-E modules (Shortwave)I have configured an 8 port etherchannel bundle between the two switches, same admin group.I would like to figure o...

network descriptioni have modular enterprise catalysts 2924 switches connected to a central catalyst 5505 switch. the modular catalyts 2924 switches are also connected in a ring. my topology is a star - ring. all my connections are dedicated 100mbps,...

I'm on a 2600 and I'm getting some things happening. We have two ISDN Lines coming in from three remote sites. The router can access the the wan. But only one of the remote site can access the wan. All of the remote sites can ping and telnet to t...

I checked the data collected by TD on Domain Discovery section and try to compare with the data which is collected All conversation for ALLAL Apps have huge difference in capacity (data amount). Any body can explain why? Thanks