07-14-2003 12:55 AM - edited 03-02-2019 08:50 AM
Dear Experts,
I'm trying to setup the Dialout with user authentication but unfortunately, I can't. Here is the error or a deb modem, can you help ?
.Jul 14 07:32:01.061 UTC: TTY34: asserting DTR
.Jul 14 07:32:01.061 UTC: TTY34: set timer type 10, 300 seconds
.Jul 14 07:32:03.309 UTC: TTY34: no timer type 2 to destroy
.Jul 14 07:32:03.309 UTC: TTY34: Line reset by "TTY Daemon"
.Jul 14 07:32:03.309 UTC: TTY34: Modem: (unknown)->HANGUP
.Jul 14 07:32:03.309 UTC: TTY34: no timer type 0 to destroy
.Jul 14 07:32:03.309 UTC: TTY34: no timer type 1 to destroy
.Jul 14 07:32:03.309 UTC: TTY34: no timer type 3 to destroy
.Jul 14 07:32:03.309 UTC: TTY34: no timer type 4 to destroy
.Jul 14 07:32:03.309 UTC: TTY34: no timer type 2 to destroy
.Jul 14 07:32:04.089 UTC: TTY34: dropping DTR, hanging up
.Jul 14 07:32:04.089 UTC: tty34: Modem: HANGUP->IDLE
.Jul 14 07:32:09.097 UTC: TTY34: restoring DTR
.Jul 14 07:32:10.097 UTC: TTY34: autoconfigure probe started
.Jul 14 07:32:10.689 UTC: %TTY-3-AUTOCONFIG: TTY34: Modem auto-configuration failed
I tried using AAA with local username and password but does not work. if use with AAA but authentication none then it works. Scaled down to no AAA but with line password does not work either.
Here is my config:
line 33 44
exec-timeout 0 30
timeout login response 300
password 7 00141215174C04140B701E1D
login
modem DTR-active
modem autoconfigure type mica1
rotary 1
autocommand exit
transport preferred none
transport input telnet
escape-character NONE
databits 7
parity even
stopbits 1
flowcontrol hardware
The router is C3640 with E1 and 10 Digital modems. IOS is 12.2(2)T1
Much thanks
Justin Vo
07-15-2003 03:53 AM
I have resolved this issue. It's basically require me to authenticate prior to initiate the dialout. I used the Dialout/Ezy software from Tactical software to solve this problem.
Now come to a new problem, I need to find out who's using the modem, for how long and the dialout number. Does anyone know how to get this ?
From the radius acccounting records, I can get who's using and the duration of the call but I'm unable to get the dialout number.
Is there something I missed in the radius server (Steel-belted Radius) or the router ? On the terminal, the syslog can tell me the dialout number but how do i map that to a particular user or IP address ?
Here is an example on the telnet session or my syslog server
Jul 15 21:21:58: %ISDN-6-DISCONNECT: Interface Serial2/0:9 disconnected from XXXX0023 , call lasted 154 seconds
All I need is just something to map to a user or IP.
Can you help ?
Kind regards,
Justin Vo
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide