displaying trap logging

[Kevin Melton]

I have a 2950 switch. When I do a "sh log" command, I get the following output:

bhicatering2#sho log

Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)

Console logging: level debugging, 1215 messages logged

Monitor logging: level debugging, 0 messages logged

Buffer logging: level debugging, 1 messages logged

File logging: disabled

Trap logging: level informational, 1219 message lines logged

Log Buffer (16384 bytes):

Nov 6 12:05:38: %SYS-5-CONFIG_I: Configured from console by vty0 (198.100.100.210)

How can I make the switch display the 1219 lines of "trap logging"???.... It seems I only have one line of output at this point...

thx

[Harold Ritter]

Trap loggins can not be displayed on the router. They are simply sent to an SNMP station. The only logging messages showed when you do a "show log" on the router are those buffered. As you can see in you "sh log" there is only one message in the buffer.

Hope this help.