I have a 2950 switch. When I do a "sh log" command, I get the following output:
bhicatering2#sho log
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Console logging: level debugging, 1215 messages logged
Monitor logging: level debugging, 0 messages logged
Buffer logging: level debugging, 1 messages logged
File logging: disabled
Trap logging: level informational, 1219 message lines logged
Log Buffer (16384 bytes):
Nov 6 12:05:38: %SYS-5-CONFIG_I: Configured from console by vty0 (198.100.100.210)
How can I make the switch display the 1219 lines of "trap logging"???.... It seems I only have one line of output at this point...
thx