Hi,
I've 2 router with peer DLSW between 2 lan.
I need that netbios hosts can communicate using DLSW.
I've some offices that are working fine with the attached conf.
You can see that the NETBIOS reachability cache list is empty !!! on one side.
I don't known why ?
***********
cisco 1720 with 12.2.8T5 ibm
sh dlsw peers
Peers: state pkts_rx pkts_tx type drops ckts TCP uptime
TCP r.r.r.r CONNECT 26634 2497 conf 0 0 0 20:50:23
DLSw Local NetBIOS Name reachability cache list
NetBIOS Name status Loc. port rif
DLSw Remote NetBIOS Name reachability cache list
NetBIOS Name status Loc. peer
A0208050 FOUND REMOTE r.r.r.r (2065)
***CONF
dlsw local-peer peer-id l.l.l.l biu-segment
dlsw remote-peer 0 tcp r.r.r.r
dlsw bridge-group 1
!
interface Loopback0
ip address l.l.l.l o.o.o.o
!
interface FastEthernet0
ip address x.y.z.u
speed auto
bridge-group 1
!
bridge 1 protocol ieee
!