Hello,
I work on a cisco router 891W (router + switch + ap) and I'd like to create a DNAT with the source being 192.168.250.1, the destination being 10.35.78.11 and the relay being 192.168.250.144.
I looked around and came to the conclusion that I should use the following command:
ip nat inside source static 10.35.78.11 192.168.250.144 extended
Yet it doesn't seem to work. I can ping 192.168.250.144 from 10.35.78.11 but not from 192.168.250.1...
There is already a NAT on the router between those two network, I wondered whether it was the cause of the malfunction of the DNAT or if it was totally unrelated and I was just doing things wrong.
I'm out of idea as to how to do this, if you could help me I'd be really grateful...
Mike
