Hi,
I had to make 4 Mbps connection to our branch office. I'am using MLPPP.
It worked for a while but a few days ago I realized that one link from two
went down. Of course the telco says everything is fine with the connection.
But is strange because I didn't change anything in the router's config.
My question is (to make sure): If i get AIS it is always a circuit error and
not a configuration error.
Thanks,
Andras
branch office:
sh controllers e1 0/0
E1 0/0 is down.
Applique type is Channelized E1 - balanced
Receiver has remote alarm.
alarm-trigger is not set
Version info Firmware: 20031209, FPGA: 11, spm_count = 0
Framing is CRC4, Line Code is HDB3, Clock Source is Line.
sh ppp multilink
Multilink1, bundle name is pan
Bundle up for 2d00h
0 lost fragments, 0 reordered, 0 unassigned
0 discarded, 0 lost received, 6/255 load
0x0 received sequence, 0x0 sent sequence
Member links: 1 active, 1 inactive (max not set, min not set)
Se0/1:1, since 2d00h, no frags rcvd
Se0/0:1 (inactive)
controller E1 0/0
channel-group 1 timeslots 1-31
main office:
sh controllers e1 4/0
E1 4/0 is down.
Applique type is Channelized E1 - unbalanced
Transmitter is sending remote alarm.
Receiver is getting AIS.
alarm-trigger is not set
Framing is CRC4, Line Code is HDB3, Clock Source is Line.
sh ppp multilink
Multilink1, bundle name is cmfdsf
Bundle up for 2d00h
0 lost fragments, 0 reordered, 0 unassigned
0 discarded, 0 lost received, 47/255 load
0x0 received sequence, 0x0 sent sequence
Member links: 1 active, 1 inactive (max not set, min not set)
Se4/1:1, since 2d00h, no frags rcvd
Se4/0:1 (inactive)
controller E1 4/0
channel-group 1 timeslots 1-31
