What is the difference between a balanced and a unbalanced e1? is it balanced uses 120ohm twisted pr and unbalanced uses 75 ohm coax and the ref to ground.
is it the same module?
if they are seperate modules, would it be physically possible to connect a balanced e1 NM to a circuit NTE using the unbalanced cable type? if so would this cause erroring.
not got physical access to the router
Applique type is Channelized E1 - balanced
Cablelength is Unknown
No alarms detected.
Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line.
Data in current interval (436 seconds elapsed):
3182 Line Code Violations, 28 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 130 Line Err Secs, 6 Degraded Mins
123 Errored Secs, 0 Bursty Err Secs, 7 Severely Err Secs, 0 Unavail Secs
Data in Interval 1:
34863 Line Code Violations, 142 Path Code Violations
0 Slip Secs, 5 Fr Loss Secs, 394 Line Err Secs, 12 Degraded Mins
373 Errored Secs, 0 Bursty Err Secs, 21 Severely Err Secs, 0 Unavail Secs
Data in Interval 2:
30586 Line Code Violations, 153 Path Code Violations
1 Slip Secs, 4 Fr Loss Secs, 383 Line Err Secs, 13 Degraded Mins
362 Errored Secs, 0 Bursty Err Secs, 21 Severely Err Secs, 0 Unavail Secs
Total Data (last 2 15 minute intervals):
65449 Line Code Violations, 295 Path Code Violations,
1 Slip Secs, 9 Fr Loss Secs, 777 Line Err Secs, 25 Degraded Mins,
735 Errored Secs, 0 Bursty Err Secs, 42 Severely Err Secs, 0 Unavail Secs
Cheers
