Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I would like to share with all you about a L2TP scenario that I have.There are some users connected in the LAC in the different networks and they need to remain separated between them.Between LAC and LNS there is a single L2TP Tunnel with Norte...
Hello, I have a MPLS VPN scenario which CE router is advertising one prefix with RT extcommunity:!route-map RT_OUT_FROM_CE permit 10 match ip address prefix-list RT_OUT_FROM_CE set extcommunity rt 323:323!This prefix is arriving in the PE router wit...
Hello,I would like to know if there is any restriction to configure BVI interface and GLBP feature.I have two routers Cisco 3845, each router has two LAN interfaces in the same network, and then I configured BVI Feature in each router. HSRP is config...
Dear All,I have a Cisco Router with IOS Adv.Sec 124-11.T3 with SSLVPN configured. It works very fine.Yesterday I updated the router to the same IOS, but new realse 124-15.T1, and then the SSLVPN doesn't work more.Are there diferent configs betwen the...
Dear All,I have a DMVPN scenario, and it works very fine. Now I would like to put a new Hub router, as backup, and between HUB1 and HUB2, I have configured HSRP and the spokes routers connect in the Virtual IP Address.After this configuration, the vp...
Hello, what line card do you have? DFC is installed in the Line card and you need to check frist. DFC will handle the traffic locally, this is the big benefit that you will have. The Mpps also will increase from 30 to 48.Best regards,Cassio
Hello,Thanks for your replay. I solved the problem using export map in the PE router, but I would like to use only CE router to handle this routing, but OK.Many thanks,Cassio
Whne I use Cisco Switch, GLBP work fine, when I use Enterays Switch, GLBP does not work, router can talk each other, but load-balacing doe not work.Thanks,Cassio
Thanks Edison,But there is communication between the Cisco routers, however there is no load balacing,Router-1Interface Grp Fwd Pri State Address Active router Standby routeBV1 10 - 110 Active 172.20.78.1 local ...
Hello,After many tests with Cisco Devices, GLBP works very fine, I did not find problem. However, when I configured Enterasys Switches, the problem happened. Devices behind Enteresys Switche can not reach GLBP IP gateway...this is may real problem no...
