02-25-2005 05:43 AM - edited 03-02-2019 09:52 PM
After configuring 2 etherchannel ports they are now going in errdisabled state after it is configured.
I then tried to set port channel 4/37,4/39 mode desirable silent. So far no luck, still getting an errdisabled state. In addition, I can't get into config t mode. It just stays at SWITCH>(enable)# mode.
03-03-2005 02:01 PM
Additionally, does it throw some kind of error ?
03-03-2005 07:44 PM
hi,
Ive have experienced and solved that problem.Please refer to this link below.
http://www.cisco.com/en/US/tech/tk389/tk214/technologies_tech_note09186a0080093dcb.shtml
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide