Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
301
Views
0
Helpful
2
Replies

Flapping Problem with 2948G

dingyii
Level 1
Level 1

‎11-07-2002 02:52 AM - edited ‎03-02-2019 02:42 AM

I set a span port 2/48 to monitor from 2/1 to 2/47 for IDS Sensor require. And the switch have not physical loop. The topology is a server connect to 2948G,and 2948G connect to Netscreen.No HSRP,No FEC. Today, I received a log say:

%SYS-4-P2_WARN: 1/Host 00:30:6e:0c:16:96 is flapping between port 2/2 and port 2/48

%SYS-4-P2_WARN: 1/Host 00:07:ec:17:b3:fc is flapping between port 2/48 and port 2/49.

I feel so strange,because the day before everything is ok.What is the reason will cause this problem?

Labels:
0 Helpful
2 Replies 2

wkumari
Level 1
Level 1

‎11-07-2002 06:39 AM

What is on ports 2/2 and 2/49? What are the devices with the MAC addresses 00:30:6e:0c:16:96 (HP something) and 00:07:ec:17:b3:fc (a cisco something)...

Is the IDS plugged directly into port 48? And are there any trunks? Hubs?

0 Helpful

dingyii
Level 1
Level 1
In response to wkumari

‎11-07-2002 08:24 AM

SGI server plugged into 2/2 ,2/49 is a uplink to NetScreen and NetScreen connect to Cisco6509. IDS is Plugged directly into Port 2/48 . No any trunks

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents