Hello all,
I've got a severe problem... I've hose the flash memory of a 2621 Router.
Question is whether there's any way to recover it or at least bring it into
a state from where it can be worked with again.
The drama in three stages :
- accidentally deleted the IOS (router booted to rommon after that)
- tried to recover IOS through xmodem (found the instructions at cisco site)
- however aborted file transfer while in progress (which hosed the router)
Since then the router doesn't come up again,
but simply shows cryptic signs when it tries to boot.
Is there any way to reset the flash memory in some defined state ? Kind of some pin to press or jumper to set or whatever ?
Any help / comment welcome ! Thanks for your efforts
Jürgen