Frame-Relay and OSPF link authentication???

[p.hagedorn]

Hy

I heard that it should possible with IOS version 12.1

In a frame-Relay Enviroment Hub and Spoke.

1 Hub and three Spokes. Running Routing Protocol OSPF.

It should be possible, when I do area0 authentication, that I have the possibility to do this only on one Spoke, altough all spokes are in Area 0.

That means I do some autentication per link.

I tryed to find something on the CCO but without success.

When anybody already know or heard about it, it would be glad to give some Info or link where I could check this.

Thanks in advance

[wassim.kreidy]

HI,

Yake a look at the following link, I think it's got the information you need. Otherwise drop me another message and I'll try to help you with your config.

http://www.cisco.com/warp/customer/104/25.shtml

Regards

Ciao :-)

[nuno.morais]

Hi.

I'm afraid it isn't possible to do. What you can do is having different passwords per interface. In your case, Hub & Spoke, if you are using a single Frame-Relay main interface or Point-to-Multipoint subinterface you have to use the same password.

Regards,

Nuno Morais