Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have a quite special Problem, that maybe is very easy to solve, but I dont get the Point. When I create a Rule in the PIX Policy under the Pic Device Manager, a I apply the rule, the rule disappaer from the PDM.the policy is also not aktive, som...
Hi all,We have a implementation with Ce560 and L3 Sw3550 with WCCPv2. We sometimes have the problem that the CE does not respond anymore out the cache, or it takes until 10sec to give some request. I know the the WCCP on 3550 has limited features but...
HyI hope that someone can Help me.I installed the Call Manager version 3.1.2c, all IPPhone are registered, everything work fine.I integrated a complete dialplan for Swiss, with all the PAtterns they are nessecary. To mention no pattern overlabs the o...
Hy I heard that it should possible with IOS version 12.1In a frame-Relay Enviroment Hub and Spoke. 1 Hub and three Spokes. Running Routing Protocol OSPF.It should be possible, when I do area0 authentication, that I have the possibility to do this onl...
Can someone Help me.I have a switch C3524XL and i would change the config-register.Please can someone tell me how I can do this in Rommon mode. And in the normal working mode.Take care Rommon is a little bit different. I tryed everything but it will ...
Hi gilles The disk has normal load. The Version that we use is Version: ce560-4.2.5.If the problem occurs the traffic is still redirected to the CE, but the answer time (out the cache) goes until 10sec. With (sh stat http request ) it increases but s...
Hi gilles The disk has normal load. The Version that we use is Version: ce560-4.2.5.If the problem occurs the traffic is still redirected to the CE, but the answer time (out the cache) goes until 10sec. With (sh stat http request ) it increases but s...
Hy We had exatly the same problem with a Meridian, we only see the name in the information element from q931.Is it possible that you can post the config from the Gateway , and when its possible also from the Maridian PABX.Thanks Philipp
Hy It looks like on the debugs that the setup message back to the CCM would be delayed on the H323 Gateway.But funny is, that the delay is it not constantely, sometimes it is shorter sometimes longer.thanks philipp
