Frame relay - FRF1.2

[chumma2002]

Hi,

I have a CISCO series of

CISCO : 2500 series

IOS version : 12.2(6a)

I configured cisco as DCE and enabled qos-autosense and traffic-shaping on CISCO serial interface.

When I am creating a new PVC it is not sending qos-parameter related information

(cir, bc, be, frame-size) in its full status message.

Any specific configurations/commands to be done on CISCO for generating this LLCP message?

Regards,

Anu

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.