Other Network Architecture Subjects

If a switch port connected to a workstation or server is configured with fast start disabled and another workstation configured with port fast disabled leaves or joins bridge what impact, if any, does it have on other ports on bridge configured with ...

Hi all,I'm looking for a Cisco switch to perform load balancing in a way that is like HP's implementation with switch meshing. Does anyone know if Cisco supports switch meshing in a way that is similar to HP's? I'm looking at the Cisco 2950 and 350...

Hi There,I'm trying to backup several remote sites' wan connection with isdn to a central site ( a hub and spoke topology for ddr backup). I want the remote sites to call the central site when the wan link goes down but not the other way round. The ...

do you know if it possible to put a time profileon a router so that ISDN/Dailer calls can only be made @ certain times

I have a 3550 switch which is stuck in boot loader mode. When I type as asked "boot" the following is displayed.switch: bootLoading "flash"...flash: permission deniedError loading "flash"Interrupt within 5 seconds to abort boot process.Boot process f...

i have 2fe2w card in my 3640 i want to do load balancing i have 2 lease lines coming in when they go to my switch which is in one /24 subnet i want them to load balance using the 2 ethernet ports i can give only one gateway is this possible by creati...

I have two Supervisors. One is identified as a WS-X6K-SUP2-2GE in module 1 whereas the second as WS-X6K-S2U-MSFC2 in module 1. Are these effectivelty the same supervisor but with different memory? Both have a WS-F6K-MSFC2 in Module 15. Do both these ...

I have still problems when dialing from the cisco 2651 to the CiscoRAS. I ping from the cisco2651 to the IP adress 192.168.10.3In earlier conversations I made some changes, but it wasn't enoughHere below you see the config files and debug informatio...

I have just replaced some 3COM Superstack 2 switches with some Catalyst 2950 switches.Since then I have the following problem:There are 2 x Novell 5 servers, one with a 3COM NIC (Even Server), the other with an Intel NIC (Odd Server), which are still...

805 router gone to " boot> " mode and password is unknown.How can break it ?

Is there any way to change the HTTP port number so that this type of traffic goes through a user specified port? Any information will be greatly appreciated.

Dear Sir/Madam,Our ISP has one Cisco Systems Router. They asked me to capture the UDP Packets which are sent to the Router (i.e. Destination Address of the IP Packet is Routers IP) .UDP Port is 50551. Please help me to do these things.Can i use RMON...

I have recently been given the task of installing 1600 routers between two locations. After the quick start wizard failed to detect our leased line, I have set the routers up using a recommended procedure from cisco as followshostname oelwein!enable...

Hello,Then i loose ip connectivity forl ong time ( about 5mn....)Do you know a command on Catalyst 2948 wich permit to refresh rapidly the cam/arp table and then to recover the ip connectivity????Thanks and regardsJerome

I have 6 3550 switches that will have our server farm connected to it,(Approx 90 Win servers), These 3550 switches will connect to our 6505 core switch.Which is the most effective way to connect these switches to the core,1) cluster all 6 3505 switch...