01-22-2003 04:29 AM - edited 03-02-2019 04:25 AM
All,
I have a descision to make.
Should I use Auto RP or BSR for dist of RP mappings
AutoRP Advantages
Can be used with admin scoping
AutoRP Disadvantages
Needs sparse-dense pim
BSR Advantages
Can run in sparse mode
open standard
BSR Disadvantages
Cannot be runing with admin scoping - why?
With can run with anycast and msdp I assume.
Are there any more reasons I should be looking at to influence my descision?
Many thx
01-28-2003 11:25 AM
Auto-RP is that it offers the ability to scope the RP address within a domain. Scoping can be achieved by defining the time-to-live (TTL) value allowed for the Auto-RP advertisements.
Hi,
BSR performs similarly to Auto-RP in that it uses candidate routers for the RP function and for relaying the RP information for a group. RP information is distributed through BSR messages, which are carried within PIM messages. PIM messages are link-local multicast messages that travel from PIM router to PIM router. Because of this single hop method of disseminating RP information, TTL scoping cannot be used with BSR.
And regarding whether to use AutoRP or BSR , cisco recommends using Auto-RP to configure RPs because it is easy to configure, well-tested, and stable.
For more information please refer :
http://www.cisco.com/en/US/tech/tk648/tk363/technologies_white_paper09186a0080
01-31-2003 07:37 AM
Many thx indeed :))
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide